#31
![]() |
|||
|
|||
![]()
Engine reassembly continues. Installed the crankshaft seals, the layshaft and cush gear.
|
#32
![]() |
|||
|
|||
![]()
Installed the bearings on the crankshaft. To install you immerse the bearings in hot gear oil which expands the metal enough to press them on to the crankshaft. Next step is to install the crankshaft/bearing into the case half that contains the cush gear.
|
#33
![]() |
||||
|
||||
![]()
Too much attention to detail. Great job!
Last edited by alfie; 27-12-2013 at 19:09. |
The Following User Says Thank You to alfie For This Useful Post: | ||
xasapis (23-06-2014) |
#34
![]() |
||||
|
||||
![]()
Sit on your eggs,Alfie.
__________________
I feel the pain of everyone Then I feel nothing |
#35
![]() |
|||
|
|||
![]()
Bottom end all buttoned up. Next is clutch and top end.
|
#36
![]() |
|||
|
|||
![]()
I finally finished the restoration of this bike. Thanks to Stathis for his generous donations!
|
The Following 15 Users Say Thank You to gransport67 For This Useful Post: | ||
AlexanderCool (22-06-2014), alfie (23-06-2014), axxis (23-06-2014), GiannisG (07-01-2015), KaKoula (23-06-2014), NikosG (23-06-2014), pepe (23-06-2014), SokoNik (23-06-2014), Stathis (23-06-2014), TARATATA (23-06-2014), thomasant (22-06-2014), tolis125 (25-06-2015), Ve-Spyrous (23-06-2014), Veloce (23-06-2014), xasapis (23-06-2014) |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|